07-14-2017, 04:35 PM
I've got a car question.
My son has a ’95 Mazda with a V6 and 5 speed manual transmission and
he’s trying to repair the clutch. The last
time I repaired a bad clutch was in my ’55 Chevy with a three on the tree. This one apparently has hydraulic cylinders,
which he has replaced but he can’t get it to bleed. He said he even tried back-bleeding but he
can’t seem to get enough pressure. Any
suggestions would be met with gratitude and written praise!
My son has a ’95 Mazda with a V6 and 5 speed manual transmission and
he’s trying to repair the clutch. The last
time I repaired a bad clutch was in my ’55 Chevy with a three on the tree. This one apparently has hydraulic cylinders,
which he has replaced but he can’t get it to bleed. He said he even tried back-bleeding but he
can’t seem to get enough pressure. Any
suggestions would be met with gratitude and written praise!